High-pressure hoses

HYDROPAPA

+380445015929

+380675072240

+380674650171

+380955382171

+380636499813

Email:   hydropapa@ukr.net

 

R 7 - HYDRAULIC PLASTIC DOUBLE BRAID HOSE

R 7 (SAE J517, EN 855, ISO 3949)

plastic high pressure hose

Double braided plastic hose, conforms to SAE J517, EN 855, ISO 3949, designed for systems using the following fluids:
Mineral-based oils, mineral-based oils with up to 40% aromatics added, rapeseed oils, bio-oils, polyglycol-based oils, water and water-oil emulsions, water-glycol emulsions, air, gas.


STRUCTURE OF THE SLEEVE:
Inner layer: polyester or polyamide
Gain: two high tenacity polyester braids
Outer layer: extremely wear-resistant polyurethane, oil, ozone, grease and weather resistant
Working temperature: - 40° Ñ to + 100° Ñ (use with air, water and water emulsions + 65° Ñ)
The advantage of this sleeve is wear resistance without stretching along the length and low weight.
Nominal diameter Inner diameter Outside diameter Operating pressure Burst pressure Bending radius Weight
mm inch mm mm bar bar mm kg/m
3 1/8 3,5 8,5 170 680 20 0,057
5 3/16 4,8 10,0 210 840 35 0,073
6 1/4 6,4 11,8 200 800 50 0,090
8 5/16 8,0 14,3 190 760 55 0,128
10 3/8 9,5 16,0 175 700 75 0,155
12 1/2 13,0 20,3 140 560 95 0,224
16 5/8 16,0 23,5 105 420 125 0,277
19 3/4 19,2 26,5 90 360 150 0,330
25 1 25,6 32,5 70 280 200 0,403
Note: It must be remembered that due to prolonged use of the hose at the operating limits (maximum working pressure, maximum temperature, minimum bending radius), the service life of the hose is reduced!
UP